● Serial Peripheral Interface(SPI)
-Standard SPI: SCLK, /CS, SI, SO, /WP, /HOLD
-Dual SPI: SCLK, /CS, IO0, IO1, /WP, /HOLD
-Quad SPI: SCLK, /CS, IO0, IO1, IO2, IO3

● Read                                                       
-Normal Read (Serial): 55MHz clock rate
-Fast Read (Serial): 120MHz clock ratewith 30PF load
-DualI/Odata transfer up to 240Mbits/S
-Quad I/O data transfer up to 480Mbits/S
-Continuous Read with 8/16/32/64-byte Wrap

● Program                                                       
SOP150-mil-Serial-input Page Program up to 256bytes
-Program Suspend and Resume

● Erase                                                       
-Block erase (64/32 KB)
-Sector erase (4 KB)
-Chip erase
-Erase Suspend and Resume

● Program/Erase Speed
-Page Program time: 0.6ms typical
-mil-Sector Erase time: 50ms typical
-Block Erase time: 0.15/0.25s typical
-Chip Erase time: 15stypical

●Flexible Architecture
-Sector of 4K-byte         
-Block of 32/64K-byte

●Low Power Consumption
-20mA maximum active current
-5uA maximum power down current

●Software/Hardware Write Protection
-3x256-Byte Security Registers with OTP Locks
-Discoverable Parameters(SFDP) register
-Enable/Disable protection with WPPin
-Write protect all/portion of memory via software
-Top or Bottom, Sector or Block selection

●Single Supply Voltage
-Full voltage range: 2.7~3.6V

●Temperature Range
-Commercial (0°Cto +70°C)
-Industrial (-40°Cto +85°C)

●Cycling Endurance/Data Retention
-Typical 100k Program-Erase cycles on any sector
-Typical 20-year data retention at +55°C